Back

S14 Capsule Machine










First use – Set up of the S14 Capsule Machine

  • Fill the tank with fresh, still water. (Pic.4).
  • Plug in the appliance and turn it on.(Pic13 & 14).
  • Make sure the lever is closed. (Pic.3).
  • Along with the A-B-C keys, the D indicator light will also alternately blink RED.
  • Place a large container (at least 250 ml) under the coffee dispensing spout (Pic.9).
  • Press one of the buttons A-B-C. Wait for the machine to complete the priming cycle and fill with water. The D indicator light switches off.
NOTE: If the buttons A-B-C and the D indicator light continue to blink after the filling procedure has ended, repeat the steps in previous point.

  • When the buttons A-B-C blink at the same time; the machine is warming up.
  • When the buttons A-B-C turn on and remain steadily lit, rinse by pressing the C button.
  • Press the button again to rinse a second time. Wait for the machine to complete the rinse cycle.
  • At the end of this operation, empty out the water from the used capsule drawer (Pic.6)

Dispensing Coffee

  • Raise the lever to open the capsule compartment (Pic.1).
  • Insert the capsule, pressing it gently into place (Pic.2).
  • Close the lever fully (Pic.3).
  • Place a cup or mug under the coffee dispensing spout (Pic.7 or 8).
Correct use of the Buttons
To dispense single or double espresso shots, use the A or B buttons only (1st and 2nd from the left respectively, lit up in WHITE). The same buttons, depending on the amount required, should also be used to dispense cocoa.
The C button (the bottom button, lit in BLUE) can be used to dispense Hot Water only with no capsule in the chamber. This button can also be used for Tea Capsules.

NOTE: If you are changing Flavours, we suggest rinsing the machine by pressing the coffee button as if to dispense a coffee without inserting a capsule.

  • The selected coffee button will blink. The appliance will stop dispensing on reaching the programmed quantity and will emit a beep.
  • Raise the lever to eject the used capsule into the drawer. (Pic.1).
  • Close the lever (Pic.3).

NOTE: The quantities of coffee dispensed can be programmed according to personal taste and the size of the cups or mugs used. (See Below)



Programming the Quantity of Coffee in a Cup

  • Raise the lever to open the capsule compartment (Pic.1).
  • Insert the capsule, pressing it gently into place (Pic.2).
  • Close the lever fully (Pic.3).
  • Place a cup or mug under the coffee dispensing spout (Pic.7 or 8).
  • Press and Hold the desired coffee button.
  • On reaching the desired amount of coffee, release the button. Now the button is programmed. The quantity of the coffee dispensed may be programmed, from a minimum of 30ml to a maximum of 250ml.
  • Recommended Programming:
    • 30ml - Espresso
    • 60ml - Double Espresso